TPE Solvent - Repair Glue.

TPE repair solvent from WM Dolls

Please Note - This product is delivered to the EU only.

This TPE repair kit contains one 20ml vial/container of Thermoplastic Elastomer (TPE) Solvent.
To be very clear, this is a solvent, NOT a glue, and is for TPE love sex dolls only.


If this solvent is used on silicone love sex dolls, it will be ineffective.


The solvent, will dissolve the TPE on both sides of the tear/cut, and begin to reform the TPE as one unbroken area of TPE. 
If applied correcctly, (please view the below videos) there will be no visible join between the two previously separate areas of TPE (as typically seen when using cyanoacrylate/superglue or adhesives.)


Once again, please view the below videos for correct and incorrect ways to apply the solvent, and please be aware that VERY LITTLE is required to repair a doll, and one container of this solvent, should last in excess of year (if not longer.)

Video - Fixing TPE with Solvent/Glue at The-Doll-House

The procedure is:
  • Clean the tear of TPE oils thoroughly with nail varnish remover (Acetone), or degreaser, and dry. Otherwise the TPE oils will inhibit the glue from working.
  • Ensure that you will be in a position to be able to easily hold the two sides of the tear together, with the 2 sides level as possible for around 2 minutes
  • Have the glue and toothpick/cocktail stick, and tissue ready
  • Open the glue container
  • Dip the stick into the glue, and try not to have an excess drop hanging off the end of the stick (no excess)
  • Replace the cap on the glue container (Important, to stop solvent evaporating)
  • Rub the stick one the inside of the tear, on both inner sides
  • Gently push the sides of the tear closed, with the two sides at even levels
  • Use a tissue to wipe away any excess that is squeezed out of the tear. I used my fingers in the video (bad practice, as this can cause fingerprint impressions on your TPE)
  • Hold the tear closed (both sides at even levels) and gently push the two sides together so there is gently force pushing the dissolving TPE sides into one piece of TPE
  • Keep together for at least 90 seconds, or until you cannot smell any solvent at the tear (I blow on this gently to promote the evaporation of the glue)
  • Relax your grip, and the tear should be sealed.
 
If there are any holes in the fix, wait 20 minutes, and repeat the process for those holes, and you will have invisibly mended the TPE.
I used my fingers to mop up and smooth the solvent on the TPE to lessen the scarring, but it is better practice to ensure the 2 sides of the tear, are level and this will make the mend invisible.

Video - Incorrect Use of Solvent

Video - Correct Use of TPE Solvent